Hjem / Nyheter / Vedlikeholdsstandarder for transmisjonskjeder

NYHETER

Vedlikeholdsstandarder for transmisjonskjeder

Update:30-11-2020
Skrevet av Admin

Den Transmisjonskjede er en svært kritisk overføringsstruktur i mekanisk utstyr, som påvirker arbeidsytelsen og levetiden til utstyret. Derfor er det svært nødvendig å vedlikeholde kjeden til ordinære tider.

  1. Den sprocket should be installed on the shaft without skew or swing. The end faces of the two sprockets in the same assembly should be in the same plane. When the center distance of the sprocket is less than 0.5 meters, the allowable deviation is 1 mm; when the center distance of the sprocket is more than 0.5 meters, the allowable deviation is 2 mm. However, it is not allowed to rub the side of the sprocket tooth. If the two-wheel knitting is too large, it will easily cause chain disconnection and accelerated wear. When replacing the sprocket, check and adjust the offset.
  2. Den tightness of the chain should be appropriate. Too tight increases power consumption and bearings are easy to wear; too loose chain is easy to jump and fall off. The tightness of the chain is: lifted or pressed down from the middle of the chain, the center distance between the two sprockets is about 2%-3%.
  3. Den chain is too long or stretched after use, and it is difficult to adjust. You can remove the chain-link depending on the situation, but it must be an even number. The chain link should pass through the back of the chain , the lock piece should be inserted outside, and the opening of the lock piece should face the opposite direction of rotation.
  4. Etter at tannhjulet er sterkt slitt, bør det nye tannhjulet og det nye kjedet skiftes ut samtidig for å sikre god inngrep. Det er ikke mulig å bare bytte nytt kjede eller nytt tannhjul alene. Ellers vil det føre til dårlig inngrep og akselerere slitasjen på det nye kjedet eller det nye tannhjulet. Når tannoverflaten på tannhjulet slites til en viss grad, bør det snus og brukes i tide (refererer til tannhjulet som brukes med en justerbar overflate). For å forlenge brukstiden.
  5. Den old chain cannot be mixed with part of the new chain, otherwise, it is easy to have an impact on the chain and break the chain.
Nyheter